FACTORY BUILT FIREPLACES
PART 1 GENERAL
1.1 DESCRIPTION OF WORK
Furnish all products, materials, accessories, and labor necessary to provide a complete installation of the factory built fireplaces within the specifications, drawings and other guidelines set forth for this project. All work shall also be performed within the scope of the manufacturers warranty.
1.2 RELATED SECTIONS
1.3 DELIVERY, STORAGE, AND HANDLING OF MATERIALS
Delivery of all products shall be scheduled so as to allow for prompt installation immediately following delivery. All materials shall be fully protected from damage from other trades as well as damage from inclement weather and other unforeseen job site hazards.
1.4 QUALITY ASSURANCE
Any variations from the manufacturers installation instructions must be approved by the manufacturers technical support department in writing and submitted to the architect prior to submitting a bid. In addition, each bidder shall submit a copy of the most recent installation instructions and product literature for the required products. All accessories required shall be fully described and noted in the bid.
PART 2 PRODUCTS
All fireplaces and required accessories shall be manufactured and approved by Superior Fireplace Company, Fullerton, CA and Union City, TN (800) 823-6224.
Superior model #CGI-BAY with all indicated and required accessories as stated within the drawings and specifications. This unit may be installed in previously existing approved wood burning fireplaces, with the following minimum firebox sizes; front width 31 1/2", front height 19 1/4", back width 22", back height 15 1/2" and depth 15 1/4". This unit is rated for 22,000 - 28,000 b.t.u.
2.3 PRODUCT APPROVALS
Fireplace products shall comply with all local building codes and regulations. In addition, products must have the following approvals and meet the following specifications:
2.4 OTHER MATERIALS
Other materials not specifically described but required for a complete and proper installation shall be new, best quality of their respective kinds, as selected by the contractor subject to the approval of the architect.
PART 3 EXECUTION
Install in accordance with the manufacturers recommendations as approved by the architect and with the requirements of authorities having jurisdiction, anchoring all components firmly into position for long life under hard use.
Upon completion of this installation, visually inspect all exposed surfaces. Touch up scratches and abrasions with touch up paint recommended by the manufacturer, making imperfection invisible to the unaided eye from a distance of five feet.
3.2 ADJUST AND CLEAN
Adjust and clean for proper operation.